• The frame is made from an extruded aluminum weldment with a durable bright yellow polyester powder coating.

• D.O.T. approved lights (bulb or LED depending on model) and reflectors are mounted on the back and both sides.

• Shock mounts provide greater bulb life and simplify bulb replacement.

• The kit uses a Reflexite label with 3 in. (76 mm) high lettering and a standard legend, ("Swings on Turns" with directional arrows).

• The unit comes with a 40 ft. (12.2 M) 18 gauge S.O. trailer cord with a heavy-duty 4-way or 6-way trailer plug for plugging into either the trailer or the vehicle pulling the trailer. This gives motorists the added information of turn signals and brake lights; not just blinking lights. Environmental concerns are also reduced as our kits don't use disposable batteries

• The width of the unit is minimized with up-right flags (included) and cordage storage arms located within the outer dimensions of the frame for storing excess cordage

• The flag holders are oversized to allow for swelling of the wooden staff when wet. Each holder includes a pin retainer to keep the flag secure during transportation

•  Positive attachment to the pole is created with an over center chain binder that uses 5 ft. (152 cm) of chain and hardened steel spikes that bury in the pole when the binder is tightened on the wooden pole only version

• Heavy duty strap binder version available for attaching to both wood or non-wooden poles.

• Sockets for both the 4-way and 6-way plugs can be ordered separately

Ordering Information

Chain Binder Attachment for wood poles only	Strap Binder Attachement for both wood and non-wood poles

Instructions for All Chain Binder Versions.

Instructions for All Strap Binder Versions.

Wiring Instructions for Light Bars