This block is used for supporting a single cable up to 2-3/4 in. (70 mm) in diameter on 1/4 - 3/8 in. (6-10 mm) bare strand prior to the lashing process.

• The frame and sheave are made from 100% heat treated aluminum alloy

• The sheave contains oilite bearings for a smooth pulling operation and a long lasting life span

• Contains steel inserts on the underside of each strand hook for smoother pulling and less wear

• Lever actuated bi-directional cam locks the frame on the strand to prevent travel while pulling in cable

• Cam automatically releases the block when pushed by the lasher from the other direction

• Contains an eye hook that allows you to lift the unit and lock it into place from the ground. (See D Cable Block Lifter) These units are normally placed anywhere from 15 ft. to 25 ft. apart on the strand depending on the cable weight and pulling conditions.

• 300 lbs. (136 kg.f) load capacity rating.

D Cable Block
P/N 72680 Weight: 3.8 lbs. (1.7 kg)  

D Cable Block Lifter

D Cable Block Lifter is specially made for putting D Cable Blocks onto suspension strand.

• Make block placement from the ground fast and easy

• Rugged aluminum alloy material

• Use with GMP Extension Handles (Lay-up Sticks)

• A cradle supports the block while a hook operates the block cam lever

P/N 07163 Weight: 12 oz. (.34 kg.)

D Cable Block Hanger Bracket

Used for hanging cable blocks at the pole as temporary support for cable or wire. Can be mounted on "J" brackets or suspension/extension bolts.

P/N 70265 Weight: 1 lb. (.45 kg.)