Strand Tensionmeter

STRAND TENSIONMETER  DISCONTINUED

Commonly referred to as a Strand Dynamometer, the Strand Tensionmeter is used in tensioning new strand and in measuring the tension in existing strand. Assures that utilities maintain proper cable clearances to comply with all requirements specified in the National Electric Safety Code’s Uniform System of Clearances.
Strand Tensionmeter in use
Strand Tensionmeter in use
  • Is a precision instrument which can quickly measure tensions of 1/4 in. (6.6M) Extra High Strength, 5/16 in. (6M), 3/8 in. (10M) and 7/16 in. (16M) Utilities Grade, zinc coated guy wires and messenger cables per ASTM A-475
  • No battery to run down and let you down-100% mechanical
  • One piece construction measures all sizes. No saddles to loose.
  • Used on strands having less than 10,000 lbs. of tension
  • The Tension meter measures tension in pounds force with an average accuracy of plus or minus 3%. The maximum error magnitude can be the greater of 7% or 150 pounds force with a 3% frequency.
  • This plated steel instrument measures the force required to deflect the strand to an out of line position, registering this force on an integral dial
  • Is furnished with an analog thermometer, temperature compensation charts, detailed instructions and a hard shell plastic carrying case cushioned with foam rubber for protection
  • A registered serial number is stamped on each handle
  • Strand tension readings may be taken at any convenient point in the span. The actual strand tension is easily determined by referring to the furnished calibration chart. The user converts the dial indicator reading into the tension value.
  • The data on the chart indicates the dial reading of the tensionmeter corresponding to the amount of strand tension, in 100 pound increments, for the normal tension range of each strand size. To ensure accurate measurements of different ambient temperature conditions, take a temperature reading with your thermometer and refer to the temperature compensation charts.Note:
    Contact GMP for any maintenance service and repairs of GMP or any older AT&T model B Strand Dynamometers.
    The GMP Strand Tensionmeter is not compatible with self support cable. Using this tool on self support will damage the cable.

subhead_spacer

Ordering Information

P/NDescriptionStrand CalibrationsWeight
70046Strand Tensionmeter 1/4 in. EHS Grade

5/16 in. Utilities Grade

3/8 in. Utilities Grade

7/16 in. Utilities Grade
11 lbs. (5kgs)
70446Strand Tensionmeter with Extended EHS Calibrations1/4 in. EHS Grade

5/16 in. EHS Grade

3/8 in. EHS Grade

7/16 in. EHS Grade

5/16 in. Utilities Grade

3/8 in. Utilities Grade

7/16 in. Utilities Grade
11 lbs. (5kgs)

1140x50Spacer_fcfcfc